The transmission system
①Motor: check whether the wiring terminals of the motor are intact, whether the motor is running properly, the electrical connector is sealed, the motor bearing is lubricated, and the motor housing is repainted. For a long period of downtime, the owner is advised to run the motor for at least 3 hours per month, keep the motor coil dry and lubricate the surface of the bearing.
②Speed reducer: check whether the speed reducer is normal. If there is any noise, replace the reducer bearing immediately.
③Belt, pulley: adjust top wire, loosen belt, extend belt service life. Check whether the belt is broken or cracked, and recommend the owner to replace the new belt when necessary. Check the belt wheel, the level of the motor, tighten the bolts, and replace the rust bolts.
④Fan: cleaning fan blade surface, check fan blade angle, fan blade and wind gap, and make adjustment.
4、The tower body appearance
①Thoroughly clean the wind, the tower and the wind guide plate to ensure the appearance of clean and beautiful.
②Tighten the bolts and replace the rusting bolts.
③Check if there is any damage or crack in the appearance of the tower body, and repair it in time.
④Check whether the wall of the tower is tight and if necessary.
5、Attachment of the cooling tower
①Check the automatic water filling device - whether the ball is damaged or not. Find abnormal timely repair and replacement.
②Rewire the cooling tower bolts, replace the rusty bolts and paint the rust iron.
③Check in and out of the pipe, the cylinder flange of the hydrator is broken or leaking. After the cooling tower has been cleaned and maintained, it is recommended that the owner use a colorful striped cloth to seal the cooling tower wind, and prevent the debris from entering the cooling tower.
In part